Executing Manual Test Cases

1. Choose which test that you want to execute in the test execution table.

2. In the table, there is a column row labeled as "Name". Navigate to the name of the test case that you want to execute and click on the test case name link.

3. You can execute the test steps from in the test steps table using the drop-down list within the "Status" column.

4. You can add attachments to a test in Test Execution and Test Steps section. Click Attachments to know more about the supported file formats.

Auto Updating Test Case Execution Status Limitations

• If the user has enabled the flag "Auto-update execution status based on test step result" in the project setup and the test step status name and execution status name does not match then the user will get the suggestion pop-up to execute the Test.

4. You can execute the overall test case by updating and changing the status within the "Execution Status" section by simply clicking on the status drop-down list and choosing a status from the following:

• Pass, Fail, WIP (Work in Progress), and Blocked.

5. After selecting the status, the status of the test case is automatically updated and the test case is now executed.

• You can change the status of the test execution at any time. If a test execution status was marked as "Fail", you can go back and change the status whenever you want.

1. To bulk execute the test steps, simply select the test steps that you want to bulk execute by using the checkboxes located on the left-hand side of the table under the "Test Step" section.

2. After selecting the desired test steps, use the "Change Bulk-Status" drop-down list in the top right of the "Test Step" section.

3. Simply select a status to execute the test steps from the following list:

1. Choose which test case that you want to individually execute in the test execution table.

2. In the table, there is a column row labeled as "Status". Navigate to the status of the test case that you want to individually want to execute.

3. Click on the status drop-down list in the table and choose from the list of statuses to update and execute the particular test case. By default, the statuses for test executions are: Pass, Fail, WIP (Work in Progress), and Blocked.

4. After selecting the status inline, the table should automatically update the status of the individual test case. The individual test case is now executed.

1. Select the test cases that you want you quickly bulk execute by using the check boxes on the left-hand side of the table.

2. Click on the "Change Bulk Status" drop-down list at the top center of the interface (right above the test execution table).

3. Choose from the list of statuses to update and execute the selected test cases. All non executed test cases will have a default status of "Not Executed". By default, the statuses for test executions are: Pass, Fail, WIP (Work in Progress), and Blocked.

4. After selecting the status, the table should automatically update the statuses of your selected test cases. These test cases are now executed.