Message - 'No failures are selected for emulation.'

Applies to AQTime 8.81, last modified on January 18, 2022

This message appears when you start profiling an application using Failure Emulator, but have not selected any failures to be emulated during the profiling session. This happens in the following cases:

  • No failures have been defined.

  • All the failures that have been defined are deselected.

To perform failure emulation, cancel the current profiling session by clicking No. Then make sure to define and select at least one failure in the Failure Emulator settings before you start the next profiling session. For instructions, see Failure Emulator Profiler - Setting Up Emulated Failures.

To start profiling without failure emulation, click Yes. You can use this mode, for example, to try out the application under normal operating conditions, or to simply monitor the application’s events, debug strings and exceptions in the Event View.

See Also

Failure Emulator Profiler
Failure Emulator Profiler - Setting Up Emulated Failures

Highlight search results