Monitor Panel Settings

Applies to AQTime 8.81, last modified on November 27, 2020

The Monitor panel offers an extensive complement of customizable options. You can check or change these options using the Monitor Options dialog. To call it, do any of the following:

  • Select Options from the context menu of the Monitor panel.

  • Select Options > Options from AQTime’s main menu and then choose the Profile Time > Monitor group in the ensuing Options dialog.

  • Select Options from the context menu of the Monitor panel.

  • Right-click Monitor in Visual Studio’s Solution Explorer and select Properties from the context menu.

  • Select Tools > Options from the main menu of Visual Studio and then choose the AQTime > Profile Time > Monitor group in the ensuing Options dialog.

  • Select Options from the context menu of the Monitor panel.

  • Select AQTime > Options from the main menu of Embarcadero RAD Studio and then choose the Profile Time > Monitor group in the ensuing Options dialog.

Note: If the Monitor panel does not support the current profiler, the settings are disabled.

The following options are available:

  • Active - Sets whether the monitoring is enabled in the panel.

  • Update interval - Sets the time interval (in seconds) after which AQTime updates the contents of the Monitor panel.

  • Show event marks - Specifies whether to display event marks (i.e. vertical lines used to mark definite time points in graphs).

  • Allow docking - Enables and disables docking within the panel. See Docking.

  • Monitoring period - Sets the time interval (in minutes) after which AQTime will clear the contents of the line-style charts.

See Also

About Monitor Panel
Options Dialog

Highlight search results