Description
Use the SetAddress method to assign a new IP address as a sequence of four numeric fields.
To set a new IP address in a textual form use the wAddress property.
Declaration
TestObj.SetAddress(Field1, Field2, Field3, Field4)
| TestObj | A variable, parameter or expression that specifies a reference to one of the objects listed in the Applies To section | |||
| Field1 | [in] | Required | Integer | |
| Field2 | [in] | Required | Integer | |
| Field3 | [in] | Required | Integer | |
| Field4 | [in] | Required | Integer | |
| Result | None | |||
Applies To
The method is applied to the following object:
View Mode
This method is available in the Object Browser panel and in other panels and dialogs in both Basic and Advanced view modes.
Parameters
The method has the following parameters:
Numeric fields that specify parts of the new IP address. The range for each field is 0 to 255. If filling the entire field is not required by the application, then you can enter fewer than three digits.
Result Value
None.
Example
To view an example that demonstrates how to use the SetAddress action, see Setting an IP Address.
See Also
Setting an IP Address
wAddress Property (IPAddress Controls)
Clear Method (IPAddress Controls)