The Pass count property of a breakpoint specifies that the execution stops at the breakpoint on every N passes. For instance, Pass Count equal to 3 stops the execution on iterations of 3, 6, 9, and so on. You can edit this property in the Breakpoints panel or in the Breakpoint Properties dialog.
When you assign the value that is greater than 0 to the Pass Count property, TestComplete changes the breakpoint mark from 
to 
(or from 
to 
) to indicate that the breakpoint is a conditional breakpoint. You can modify this property even if the breakpoint is disabled (in this case, TestComplete changes the mark from 
to 
).
See Also
Conditional Breakpoints
Using Breakpoints
About Breakpoints Panel
Breakpoint Properties Dialog